Metalworking / Finishing / Drawing & Stamping

Hydroblend Proportioners are used extensively in the metalworking industry to mix water-soluble coolants, lubricants and low dilution high viscosity drawing and stamping compounds. Ensuring your metalworking concentrates are mixed properly, the Hydroblend will do its part to optimize your efficiency and profitability. At Hydroblend, quality and reliability are never compromised.

The Hydroblend is a water powered chemical metering pump and can therefore be located near an isolated water source without electrical connections. Installation is simple, straightforward and takes very little time.

Your metalworking concentrate will perform as intended only if it is diluted properly. A consistent and accurately diluted effluent will reduce waste, extend tool life, improve surface finish, and optimize sump life.

Recommended Hydroblend Pumps / Systems:

Synthetic & Semi Synthetic Cutting & Grinding Fluids
Low Viscosity
Model #6080-A-V (Max 8oz/gallon)
Model #6120-A-V (Max 12oz/gallon)
Model #6180-A-V (Max 18oz/gallon)

Soluble Oils
Viscosity to 70 cSt @ 100F
Model #6200-A-V (Max 20oz/gallon)
Model #6320-A-V (Max 32oz/gallon)

Soluble Oils
Viscosity to 150 cSt @ 100F
Model #6320-A-V (Max 32oz/gallon)
Model #6470-A-V (Max 47oz/gallon)
Model #6850-A-V (Max 85oz/gallon)

Metal Forming Compounds
Viscosity to 1,300 cSt @ 100F
Model #086-6850-A-V (Max 85oz/gallon)
Model #087-6470-A-V (Max 47oz/gallon)

* Other units available upon request, and based on your proportioning needs.

Home  |  Contact Us  |  Privacy Policy

© Copyright 2016, Hydroblend Int'l.